Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Aesthetics Question - 38-7 - Should I "fix" it?
#3

Tell you what...I'll take the other side on this one. Icon_smile

Normally, I'd dive right in and put it back to it's original configuration, especially if I got it at a swap meet or someplace else (without the historical significance to go with it). However, since you have a GREAT story associated with it, I'd leave this one be. That's aside from recapping it. But I would leave the modification alone, just because you have this terrific story to go with it.

Just my $0.02.

Bill

Sent from my Pentium II on the AT&T Dial Network


Messages In This Thread
Aesthetics Question - 38-7 - Should I "fix" it? - by Guest - 09-12-2006, 03:53 AM
[No subject] - by Guest - 09-12-2006, 11:08 AM
[No subject] - by Bill Hutchinson - 09-14-2006, 04:45 PM
The decision is getting easier - by Guest - 09-17-2006, 08:25 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM

[-]
Who's Online
There are currently 3943 online users. [Complete List]
» 2 Member(s) | 3941 Guest(s)
AvatarAvatar

>