Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-1213
#3

Some of that aging test equipment may need an overhaul to be safe and accurate. Namely filter capacitors, wax capacitors and resistors that have gone up beyond tolerance. Then on to the radio, same needs to be done, all before powering up slowly with a variac!


Messages In This Thread
Philco 46-1213 - by wakani - 10-08-2011, 09:52 AM
Re: Philco 46-1213 - by Chicago Jimmy - 10-08-2011, 01:57 PM
Re: Philco 46-1213 - by codefox1 - 10-08-2011, 02:07 PM
Re: Philco 46-1213 - by wakani - 10-08-2011, 07:26 PM
Re: Philco 46-1213 - by Chicago Jimmy - 10-09-2011, 10:20 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Thank you Rod and Paul I took a break, did some yard work and Rod "Therefore, it appears cap 40 is connected backw...osanders0311 — 06:35 PM
Philco 45L Initial Check Up
Hello, I am in the process of checking out a Philco 45L. My question is does this model suffer from the Philco coil r...dconant — 06:11 PM
Table radio 51C or 52C?
Purchased a table radio at auction, not because I had to have it, but because no one else bid on it.  $5  Unable to fi...antiqueradionut — 05:14 PM
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM

[-]
Who's Online
There are currently 1013 online users. [Complete List]
» 2 Member(s) | 1011 Guest(s)
AvatarAvatar

>