Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

AC/DC radio pilot light bulbs
#1

Working on a 46-420 chassis that has a problem that caused the pilot light to burn out. Not sure what the problem is, but what kind of bulbs do these sets take? These are not what I usually work on, my sets are mainly 1930-38....


Messages In This Thread
AC/DC radio pilot light bulbs - by TA Forbes - 10-10-2011, 09:57 PM
Re: AC/DC radio pilot light bulbs - by John R - 10-10-2011, 10:44 PM
Re: AC/DC radio pilot light bulbs - by 7estatdef - 10-11-2011, 07:40 AM
Re: AC/DC radio pilot light bulbs - by TA Forbes - 10-11-2011, 02:00 PM
Re: AC/DC radio pilot light bulbs - by 7estatdef - 10-11-2011, 02:56 PM
Re: AC/DC radio pilot light bulbs - by Arran - 10-12-2011, 01:17 AM
Re: AC/DC radio pilot light bulbs - by LASJayhawk - 10-29-2011, 11:13 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6313 online users. [Complete List]
» 2 Member(s) | 6311 Guest(s)
AvatarAvatar

>