Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 620 question
#1

Just picked it up this weekend. Case in great shape but it's been electronically molested by someone. Powered it up and it sounds like I've got a signal tracer on it. Volume control has no effect, very loud always. Tone control changes pitch. Planning to start on it tomorrow by looking for short in 6A7. Can anyone give me a heads up on this anomily? Any help would be appreciated
http://www.nostalgiaair.org/PagesByModel...013804.pdf

Danny


Messages In This Thread
Philco 620 question - by Danny - 10-11-2011, 09:55 PM
Re: Philco 620 question - by Arran - 10-12-2011, 12:14 AM
Re: Philco 620 question - by Danny - 10-12-2011, 07:19 AM
Re: Philco 620 question - by Arran - 10-12-2011, 10:15 PM
Re: Philco 620 question - by Danny - 10-12-2011, 10:53 PM
Re: Philco 620 question - by TA Forbes - 10-12-2011, 10:59 PM
Re: Philco 620 question - by Danny - 10-13-2011, 11:14 AM
Re: Philco 620 question - by codefox1 - 10-13-2011, 04:56 PM
Re: Philco 620 question - by Glenn Roberts - 10-13-2011, 05:22 PM
Re: Philco 620 question - by Danny - 10-14-2011, 11:23 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 3665 online users. [Complete List]
» 1 Member(s) | 3664 Guest(s)
Avatar

>