Philco 620 question

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 620 question

Danny
Member

Posts: 64
Threads: 22
Joined: Oct 2006
City: Acworth State, Province, Country: GA

10-12-2011, 07:19 AM

I've replaced the caps on all 3 VC connectors, but I will replace the one on the center tap again. I lifted 3 of the condenser blocks and found they have been restored. Maybe I'll check the rest just to be sure. Taking an inventory sounds like good advice to me, never thought of that. Arran, thanks for the help and I'll keep you posted.

Danny

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 620 question - by Danny - 10-11-2011, 09:55 PM

Re: Philco 620 question - by Arran - 10-12-2011, 12:14 AM

Re: Philco 620 question - by Danny - 10-12-2011, 07:19 AM

Re: Philco 620 question - by Arran - 10-12-2011, 10:15 PM

Re: Philco 620 question - by Danny - 10-12-2011, 10:53 PM

Re: Philco 620 question - by TA Forbes - 10-12-2011, 10:59 PM

Re: Philco 620 question - by Danny - 10-13-2011, 11:14 AM

Re: Philco 620 question - by codefox1 - 10-13-2011, 04:56 PM

Re: Philco 620 question - by Glenn Roberts - 10-13-2011, 05:22 PM

Re: Philco 620 question - by Danny - 10-14-2011, 11:23 AM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6969 online users. [Complete List]
» 2 Member(s) | 6967 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me