Mershon Caps

Thread Rating:

Mershon Caps

Phlogiston
Radio-Fixer-Upper

Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)

10-12-2011, 10:57 PM

Could you post the measurements on those things before you take them apart?

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/

« Next Oldest | Next Newest »

Messages In This Thread

Mershon Caps - by ipwizard - 10-12-2011, 10:34 PM

Re: Mershon Caps - by Phlogiston - 10-12-2011, 10:57 PM

Re: Mershon Caps - by TA Forbes - 10-12-2011, 11:04 PM

Re: Mershon Caps - by ipwizard - 10-12-2011, 11:41 PM

Re: Mershon Caps - by Phlogiston - 10-13-2011, 12:10 AM

Re: Mershon Caps - by Arran - 10-13-2011, 12:54 AM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6411 online users. [Complete List]
» 2 Member(s) | 6409 Guest(s)