Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 80 oscillator
#8

I think it would be better to test it in circuit. The coil has a few windings on in and it might be easier to figure out by seeing if it will oscillate rather than the resonance of the windings. Does your set use #36 tubes? I've got a couple of model 84's those have round cans but use #77 tubes
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 80 oscillator - by johnfin - 10-12-2011, 01:02 PM
Re: Philco 80 oscillator - by johnfin - 10-12-2011, 04:27 PM
Re: Philco 80 oscillator - by 7estatdef - 10-12-2011, 05:51 PM
Re: Philco 80 oscillator - by johnfin - 10-12-2011, 07:53 PM
Re: Philco 80 oscillator - by 7estatdef - 10-12-2011, 08:44 PM
Re: Philco 80 oscillator - by johnfin - 10-13-2011, 08:22 AM
Re: Philco 80 oscillator - by johnfin - 10-13-2011, 08:23 AM
Re: Philco 80 oscillator - by 7estatdef - 10-13-2011, 05:51 PM
Philco the squirrel - by johnfin - 10-17-2011, 10:02 PM
Re: Philco 80 oscillator - by 7estatdef - 10-18-2011, 05:26 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6972 online users. [Complete List]
» 1 Member(s) | 6971 Guest(s)
Avatar

>