1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Model 76 output transformer
SamTanner
Junior Member
**
Posts: 8
Threads: 2
Joined: Jul 2011
City: Loxley, AL 36551
#6

10-20-2011, 08:23 PM
Hi John, unfortunately Gary has already sold that one. When I learned that earlier today, I posted here - and now I've written Gary back with the impedance values to see if he has something similar. Thanks for looking!

-Sam T.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Model 76 output transformer - by SamTanner - 10-20-2011, 12:21 PM
Re: Model 76 output transformer - by John R - 10-20-2011, 02:43 PM
Re: Model 76 output transformer - by Ron Ramirez - 10-20-2011, 06:34 PM
Re: Model 76 output transformer - by SamTanner - 10-20-2011, 07:38 PM
Re: Model 76 output transformer - by John R - 10-20-2011, 08:02 PM
Re: Model 76 output transformer - by SamTanner - 10-20-2011, 08:23 PM
Re: Model 76 output transformer - by Arran - 10-20-2011, 10:03 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 3753 online users. [Complete List]
» 1 Member(s) | 3752 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration