Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 80 7421 Transformer
#2

I don't have a parts list for that set so I'm not sure which transformer you are referring to. However don't know if it matters much. I'm thinking it's the power transformer. The simplest thing to do is unsolder the wire and slip the appropriate sized shrink tubing over it and then use a heat gun to shrink it. Resolder and your done.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 80 7421 Transformer - by Bradley Rush - 11-03-2011, 01:13 AM
Re: Philco 80 7421 Transformer - by 7estatdef - 11-03-2011, 02:49 AM
Re: Philco 80 7421 Transformer - by Bradley Rush - 11-03-2011, 08:47 AM
Re: Philco 80 7421 Transformer - by Carl Travis - 11-03-2011, 09:15 AM
Re: Philco 80 7421 Transformer - by 7estatdef - 11-03-2011, 11:10 AM
Re: Philco 80 7421 Transformer - by Bradley Rush - 11-04-2011, 09:39 AM
Re: Philco 80 7421 Transformer - by Ron Ramirez - 11-04-2011, 09:51 AM
Re: Philco 80 7421 Transformer - by Bradley Rush - 11-05-2011, 12:43 AM
Re: Philco 80 7421 Transformer - by Bradley Rush - 11-05-2011, 06:17 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6920 online users. [Complete List]
» 2 Member(s) | 6918 Guest(s)
AvatarAvatar

>