Model 60 Part ID

Thread Rating:

Model 60 Part ID

PhilcoMike
Member

Posts: 244
Threads: 11
Joined: Oct 2011
City: Black Mountain, NC

11-04-2011, 09:02 AM

Try this color chart page:
http://www.radioremembered.org/capcode.htm

Also note from this page that these are often needing replacement:
http://antiqueradio.org/recap.htm

Thanks,

Mike

Cossor 3468
GE 417A
Philco 118H
Radiola 17/100
Scott 800B6
Silvertone 6130
Stromberg 535M
Truetone D1952

Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 60 Part ID - by Caperodder - 11-03-2011, 04:54 PM

Re: Model 60 Part ID - by PhilcoMike - 11-04-2011, 09:02 AM

Re: Model 60 Part ID - by Arran - 11-05-2011, 11:30 PM

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6911 online users. [Complete List]
» 1 Member(s) | 6910 Guest(s)