1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
40-150 Update
rocketeer
Senior Member
****
Posts: 462
Threads: 40
Joined: Jun 2010
City: Lehighton State, Province, Country: PA
#3

11-05-2011, 06:52 PM
Thanks, I know what to replace, I was asking why this appears to be fairly common since I have now seen three instances of this identical repair using a pair of parallel caps on a 40-150. I was also commenting on all the pins being soldered together on the original cap with one half of it still connected in circuit. I probably could have worded the question better.

Larry
Find
« Next Oldest | Next Newest »


Messages In This Thread
40-150 Update - by rocketeer - 11-04-2011, 06:43 PM
Re: 40-150 electrolytics question - by rocketeer - 11-05-2011, 06:52 PM
Re: 40-150 electrolytics question - by Arran - 11-05-2011, 11:04 PM
Re: 40-150 electrolytics question - by gvel - 11-06-2011, 09:11 AM
Re: 40-150 electrolytics question - by rocketeer - 11-06-2011, 10:30 AM
Re: 40-150 electrolytics question - by 7estatdef - 11-08-2011, 04:37 PM
Re: 40-150 electrolytics question - by rocketeer - 11-20-2011, 03:53 PM
Re: 40-150 Update - by gvel - 11-20-2011, 05:49 PM
Re: 40-150 Update - by rocketeer - 11-21-2011, 05:55 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6126 online users. [Complete List]
» 5 Member(s) | 6121 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration