Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Newest and Best yet! AK 206
#8

I think that RCA may have licenced out the circuit used in the model 128 to a number of companies during 1934-35, I have a CGE M62 a Canadian Sparton, and a Serenader made by Dominion Electrohome that all used similar circuitr. In fact the Sparton and the G.E are almost identical except for the chassis layout and that the Sparton only has two bands, tha parts values are almost the same. What I find strange is Atwater Kent still using 2.5 volt tubes in 1934, unless they introduced the model in 1933, even RCA was moving away from 2.5 volt tubes at that time. In terms of AK verses Philco in terms of quality, although the AKs appear to be more neatly assembled I would take a Philco power transformer over an Atwater Kent unit any day of the week from 1930-32 period at least.
Regards
Arran


Messages In This Thread
Newest and Best yet! AK 206 - by 7estatdef - 11-07-2011, 11:50 PM
Re: Newest and Best yet! AK 206 - by TA Forbes - 11-08-2011, 02:00 AM
Re: Newest and Best yet! AK 206 - by Ron Ramirez - 11-08-2011, 03:14 PM
Re: Newest and Best yet! AK 206 - by 7estatdef - 11-08-2011, 04:16 PM
Re: Newest and Best yet! AK 206 - by Texasrocker - 11-09-2011, 10:30 AM
Re: Newest and Best yet! AK 206 - by Jayce - 11-09-2011, 12:40 PM
Re: Newest and Best yet! AK 206 - by 7estatdef - 11-10-2011, 08:47 PM
Re: Newest and Best yet! AK 206 - by Arran - 11-10-2011, 11:29 PM
Re: Newest and Best yet! AK 206 - by Eliot Ness - 11-11-2011, 10:30 AM
Re: Newest and Best yet! AK 206 - by TA Forbes - 11-13-2011, 01:19 AM
Re: Newest and Best yet! AK 206 - by Phlogiston - 12-20-2011, 11:22 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4393 online users. [Complete List]
» 1 Member(s) | 4392 Guest(s)
Avatar

>