48-206 RESTORATION, NEED HELP

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

48-206 RESTORATION, NEED HELP

tab10672
Senior Member

Posts: 411
Threads: 42
Joined: Sep 2008
City: Ironton Ohio

11-15-2011, 12:06 AM

Finally, I was bypassing resistors with a decade box and found a plate resistor on the 50A5 way out of spec. (even though it was a new flame proof resistor) as soon as I touched the leads across it, the volume trippled, it now plays perfect.
Thanks to everyone for ther help and suggestions.

Find

« Next Oldest | Next Newest »

Messages In This Thread

48-206 RESTORATION, NEED HELP - by tab10672 - 11-11-2011, 04:46 PM

Re: 48-206 RESTORATION, NEED HELP - by Dave - 11-11-2011, 05:02 PM

Re: 48-206 RESTORATION, NEED HELP - by tab10672 - 11-12-2011, 02:18 AM

Re: 48-206 RESTORATION, NEED HELP - by codefox1 - 11-12-2011, 02:24 PM

Re: 48-206 RESTORATION, NEED HELP - by tab10672 - 11-12-2011, 07:40 PM

Re: 48-206 RESTORATION, NEED HELP - by codefox1 - 11-13-2011, 01:02 AM

Re: 48-206 RESTORATION, NEED HELP - by tab10672 - 11-14-2011, 05:47 PM

Re: 48-206 RESTORATION, NEED HELP - by 7estatdef - 11-14-2011, 07:02 PM

Re: 48-206 RESTORATION, NEED HELP - by tab10672 - 11-15-2011, 12:06 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me