1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Value of caps in block?????
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#4

11-16-2011, 08:23 PM
Dan - No problem, really. Icon_smile

I see Chuck doesn't have 4989-Z listed on his site.

I don't have the Philco Condensers And More book by Ray Bintliff, but I have an earlier edition - The Radio Collector's Guide to Philco Bakelite Block Condensers, 2nd Edition.

See drawing below.

[Image: http://i326.photobucket.com/albums/k420/...bblock.jpg]

According to the book I have, terminals 1 and 8 are connected to common ground.

One .09 uF cap connects from 8 to 7.

The other .09 uF cap connects from 8 to 5.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
Value of caps in block????? - by Dan Walker - 11-16-2011, 04:19 PM
Re: Value of caps in block????? - by Ron Ramirez - 11-16-2011, 06:09 PM
Re: Value of caps in block????? - by Dan Walker - 11-16-2011, 06:53 PM
Re: Value of caps in block????? - by Ron Ramirez - 11-16-2011, 08:23 PM
Re: Value of caps in block????? - by Texasrocker - 11-16-2011, 09:39 PM
Re: Value of caps in block????? - by LASJayhawk - 12-08-2011, 10:15 PM
Re: Value of caps in block????? - by Ron Ramirez - 12-09-2011, 06:32 AM
Re: Value of caps in block????? - by DeckApe - 12-11-2011, 12:54 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6250 online users. [Complete List]
» 4 Member(s) | 6246 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration