1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Advice on Philco 70A basket case
Terry Burns
Member
***
Posts: 66
Threads: 2
Joined: Dec 2005
City: Marion Il.
#23

11-17-2011, 05:15 PM
Hi Mark,
Thats great you got it out. Pretty ingenious using a gear puller! If you were like me I coaxed it along with some kind words (right). Now you can start on winding the coil. I'm sure you can come up with a better arrangement than I used. There is always a way to build a better mouse trap. If you got the pin out you can wind the coil! Take your time and do some research. Don't be afraid to try it. I took it one problem at a time.
Hi Terry,
That sounds like a good idea. I'm sure that other folks would have something to contribute. Glad my pictures helped.

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Re: Advice on Philco 70A basket case - by morzh - 11-15-2011, 12:08 PM
Re: Advice on Philco 70A basket case - by Terry Burns - 11-17-2011, 05:15 PM
Re: Advice on Philco 70A basket case - by Arran - 11-20-2011, 01:19 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3015 online users. [Complete List]
» 3 Member(s) | 3012 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration