Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

no reception 57C
#9

Hello Greg and Terry,

Thanks for your input.

For old resistor wattage found the answer on the Philcorepairbench site, you can determine the proper wattage based on the size, see attached site.

http://www.philcorepairbench.com/resistcompare.htm

Definitely will rewind the primary instead of replacing the coil.

Terry, The set was already recapped when I found it, I verified that It was done correctly.

Will let you know results asap..

Kurt


Messages In This Thread
no reception 57C - by kbm37-630 - 11-12-2011, 08:43 PM
Re: no reception 57C - by Ron Ramirez - 11-13-2011, 07:30 AM
Re: no reception 57C - by Ron Ramirez - 11-13-2011, 07:33 AM
Re: no reception 57C - by kbm37-630 - 11-13-2011, 01:44 PM
Re: no reception 57C - by 7estatdef - 11-14-2011, 06:37 PM
Re: no reception 57C - by kbm37-630 - 11-19-2011, 10:50 AM
Re: no reception 57C - by gvel - 11-20-2011, 10:51 AM
Re: no reception 57C - by 7estatdef - 11-20-2011, 03:34 PM
Re: no reception 57C - by kbm37-630 - 11-20-2011, 06:16 PM
Re: no reception 57C - by 7estatdef - 11-21-2011, 02:09 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6615 online users. [Complete List]
» 6 Member(s) | 6609 Guest(s)
AvatarAvatarAvatarAvatar
AvatarAvatar

>