Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

no reception 57C
#10

Well I think I would start poking around with my volt meter and see if it has HV where it need to be.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
no reception 57C - by kbm37-630 - 11-12-2011, 08:43 PM
Re: no reception 57C - by Ron Ramirez - 11-13-2011, 07:30 AM
Re: no reception 57C - by Ron Ramirez - 11-13-2011, 07:33 AM
Re: no reception 57C - by kbm37-630 - 11-13-2011, 01:44 PM
Re: no reception 57C - by 7estatdef - 11-14-2011, 06:37 PM
Re: no reception 57C - by kbm37-630 - 11-19-2011, 10:50 AM
Re: no reception 57C - by gvel - 11-20-2011, 10:51 AM
Re: no reception 57C - by 7estatdef - 11-20-2011, 03:34 PM
Re: no reception 57C - by kbm37-630 - 11-20-2011, 06:16 PM
Re: no reception 57C - by 7estatdef - 11-21-2011, 02:09 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM
Restoring Philco 96
I have eventually replaced the speaker and shot the video, which only shows the upper part of the dial as the hum is ver...morzh — 09:24 PM
Rogers Majestic R-646
Kinda weird to see both open Nothing weird if you remember that this radio is about 100 years old  :)Vlad95 — 07:49 PM
Philco 42-345 Restoration/Repair
I believe I'm making progress, resistors have been rechecked and corrected, removed that ugly blue capacitor and more wi...osanders0311 — 07:38 PM
Philco Model 16 wiring question
Thanks Morzh Yes I recapped everything and replaced almost all the resistors as well. I redid #99 with .015 safety ca...bobclausen — 07:11 PM
Philco Model 16 wiring question
Well...pull out every single load of the transformer. For every winding. Unsolder if needed. Then re-do your dim bulb....morzh — 07:02 PM
Rogers Majestic R-646
Kinda weird to see both open, but once you get it up and running, really pay attention to your sound. Listen for loud cr...TV MAN — 06:59 PM
Rogers Majestic R-646
Vlad; I was just reminded of something else, I'm not sure why but many Rogers built sets do seem to have open primari...Arran — 04:40 PM
Rogers Majestic R-646
Thanks RpdB I don't think there's much difference with interstage transformers of different models other than dimersion...Vlad95 — 03:27 PM

[-]
Who's Online
There are currently 1020 online users. [Complete List]
» 1 Member(s) | 1019 Guest(s)
Avatar

>