11-25-2011, 04:47 AM
Hi Francis and Welcome!
To check the osc coil measure the resistance from the cathode pin of the 36 tube to the connection on the osc coil that has the resistor and mica cap connected to it. With the set unplugged you should read a very low resistance between these two points if the winding is good like 10 ohms or less. Anything higher it's time to rewind.
Terry
To check the osc coil measure the resistance from the cathode pin of the 36 tube to the connection on the osc coil that has the resistor and mica cap connected to it. With the set unplugged you should read a very low resistance between these two points if the winding is good like 10 ohms or less. Anything higher it's time to rewind.
Terry
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
