Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Antenna for Philco Radio
#13

For reception this is not critical for the kind of radiography most of us require. With the variety of stations/frequencies we listen to (KHz/MHz) a simple longwire is sufficient.

In the military they use a matching unit that electrically "matches" the fixed length antenna included with the set to the frequency that is being broadcast/recieved.

I have a couple of "inverted L" antennas here. These are pretty good if you have an antenna inside your home. Also have a pretty long one that goes up one side of a large series of 3 windows, across the tops, and back down the opposite side. It is my best antenna. Go figure.....

In my former life the antenna configuration was critical in term of length, orientation, and take off angle. But in these cases we were given a set of frequencies to use and it was easier to prepare your system before you went out in the "bush."


Messages In This Thread
Antenna for Philco Radio - by SKW40 - 11-21-2011, 10:59 PM
Re: Antenna for Philco Radio - by TA Forbes - 11-22-2011, 07:43 PM
Re: Antenna for Philco Radio - by SKW40 - 11-23-2011, 12:08 AM
Re: Antenna for Philco Radio - by 7estatdef - 11-23-2011, 12:48 AM
Re: Antenna for Philco Radio - by TA Forbes - 11-23-2011, 04:53 PM
Re: Antenna for Philco Radio - by 7estatdef - 11-23-2011, 05:06 PM
Re: Antenna for Philco Radio - by Texasrocker - 11-24-2011, 12:11 AM
Re: Antenna for Philco Radio - by TA Forbes - 11-24-2011, 03:59 PM
Re: Antenna for Philco Radio - by Texasrocker - 11-27-2011, 01:04 AM
Re: Antenna for Philco Radio - by Marsupial - 11-27-2011, 01:44 AM
Re: Antenna for Philco Radio - by TA Forbes - 11-27-2011, 02:29 AM
Re: Antenna for Philco Radio - by Marsupial - 11-27-2011, 10:45 AM
Re: Antenna for Philco Radio - by TA Forbes - 11-27-2011, 10:03 PM
Re: Antenna for Philco Radio - by BDM - 12-08-2011, 11:26 AM
Re: Antenna for Philco Radio - by BDM - 12-08-2011, 11:30 AM
Re: Antenna for Philco Radio - by codefox1 - 12-08-2011, 12:18 PM
Re: Antenna for Philco Radio - by BDM - 12-08-2011, 04:39 PM
Re: Antenna for Philco Radio - by fixinmyphilco - 12-10-2011, 08:24 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural....morzh — 08:40 PM
Hickok AC51 tube tester
I thought the 83 tube was bad because it looked white but it tests strong. Blue gassy though. I checked the fuse, it was...martinj — 08:37 PM
Shadow Meter Bulb
Ross I am not sure what current limiting effect the incandescent provides. They are two different parts of the sch...morzh — 08:31 PM
12' Philco
Bob Thanks for that photo. I have been looking for it, and I cannot find anythinmg on the web. I forgot it was here...morzh — 08:29 PM
Shadow Meter Bulb
I think after all has been said, I will use the same bulb that is specified for the dial pilot light which is a #55. I ...georgetownjohn — 07:31 PM
12' Philco
There was also this Philco! klondike98 — 07:25 PM
HiFi (Chifi) tube amp build - but my own design.
I expected a challenge and this is just part of it. But, it's also supposed to be fun, entertaining, informative and enj...TV MAN — 07:12 PM
Shadow Meter Bulb
Butting in here with a question. Since the shadow meter is connected directly to the 1st and 2nd I.F.'s wouldn't the met...RossH — 06:43 PM
HiFi (Chifi) tube amp build - but my own design.
Mike, Tim; you are about to enter the twilight zone. Doo doo doo doo, doo doo doo doo This is something alright. I'm go...RodB — 06:26 PM

[-]
Who's Online
There are currently no members online.

>