1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Restoring 38-7CS cabinet
Bob Andersen
Phorum Expert
*****
Posts: 804
Threads: 42
Joined: Dec 2008
City: Chicago, IL
#9

01-01-2012, 04:55 PM
peterc Wrote:2. any tricks to disassembling the electronics and speaker from the cabinet? I haven't even looked under there except to verify that it is a 38-7CS.

As I recall there are four small bolts holding the speaker on. Remove the nuts from the back while being careful not to damage the speaker cone. The chassis is mounted at a right angle and bolted to the underside of the top. I used a rachet wrench with extension to get up in there.

Good luck.
Website Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Restoring 38-7CS cabinet - by peterc - 12-14-2011, 10:22 AM
Re: Restoring 38-7CS cabinet - by Bob Andersen - 12-16-2011, 12:58 PM
Re: Restoring 38-7CS cabinet - by peterc - 12-17-2011, 09:08 AM
Re: Restoring 38-7CS cabinet - by Ron Ramirez - 12-17-2011, 09:50 AM
Re: Restoring 38-7CS cabinet - by Bob Andersen - 12-17-2011, 08:29 PM
Re: Restoring 38-7CS cabinet - by peterc - 12-28-2011, 10:21 PM
Re: Restoring 38-7CS cabinet - by LASJayhawk - 12-29-2011, 03:03 AM
Re: Restoring 38-7CS cabinet - by peterc - 12-29-2011, 10:35 AM
Re: Restoring 38-7CS cabinet - by Bob Andersen - 01-01-2012, 04:55 PM
Re: Restoring 38-7CS cabinet - by peterc - 01-02-2012, 10:04 PM
Re: Restoring 38-7CS cabinet - by fixinmyphilco - 01-19-2012, 08:05 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration