1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Help Please! 38-116 Troubles
bm071
Member
***
Posts: 53
Threads: 12
Joined: Jun 2011
City: Lexington, N.C. 27292
#15

12-01-2011, 09:47 PM
I replaced the 1 meg resistor and re-connected the cap wire circuit on the 6r7 1st audio tube. I have 89 volts at pin 3 on the 6r7. The 1st & 2nd IF tubes(6k7's) 247 volts pin 3, 84volts pin4, and -4.5 pin 5.

The voltage at resistors is -15.4
I cleaned the tuning condesor and blew the dust out of the IF coils but it did not help the squeal. I will have to see if I can get my hands on a signal tracer. Ebay maybe?

Bob
Find
« Next Oldest | Next Newest »


Messages In This Thread
Help Please! 38-116 Troubles - by bm071 - 11-28-2011, 01:54 PM
Re: Help Please! 38-116 Troubles - by 7estatdef - 11-28-2011, 02:31 PM
Re: Help Please! 38-116 Troubles - by bm071 - 11-28-2011, 09:32 PM
Re: Help Please! 38-116 Troubles - by 7estatdef - 11-28-2011, 10:25 PM
Re: Help Please! 38-116 Troubles - by bm071 - 11-29-2011, 01:18 PM
Re: Help Please! 38-116 Troubles - by bm071 - 11-29-2011, 09:38 PM
Re: Help Please! 38-116 Troubles - by 7estatdef - 11-29-2011, 09:55 PM
Re: Help Please! 38-116 Troubles - by bm071 - 11-29-2011, 11:52 PM
Re: Help Please! 38-116 Troubles - by 7estatdef - 11-30-2011, 05:36 PM
Re: Help Please! 38-116 Troubles - by bm071 - 11-30-2011, 10:35 PM
Re: Help Please! 38-116 Troubles - by 7estatdef - 11-30-2011, 11:19 PM
Re: Help Please! 38-116 Troubles - by bm071 - 12-01-2011, 08:06 AM
Re: Help Please! 38-116 Troubles - by 7estatdef - 12-01-2011, 05:51 PM
Re: Help Please! 38-116 Troubles - by bm071 - 12-01-2011, 09:47 PM
Re: Help Please! 38-116 Troubles - by bm071 - 12-01-2011, 10:34 PM
Re: Help Please! 38-116 Troubles - by 7estatdef - 12-01-2011, 11:28 PM
Re: Help Please! 38-116 Troubles - by bm071 - 12-15-2011, 07:40 PM
Re: Help Please! 38-116 Troubles - by 7estatdef - 12-15-2011, 08:31 PM
Re: Help Please! 38-116 Troubles - by bm071 - 12-20-2011, 09:08 PM
Re: Help Please! 38-116 Troubles - by codefox1 - 12-21-2011, 01:40 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6315 online users. [Complete List]
» 4 Member(s) | 6311 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration