38-116xx project

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

38-116xx project

Radioroslyn
Phorum Expert

Posts: 7,297
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

12-03-2011, 05:50 PM

If the 38-116 plays like it's predecessor (37-116) I'm sure you will be very happy with it. The only bad part is that there isn't all that much to listen to. A lot of us have gone the route of using a small transmitter to broadcast are own favorite programing. I'm into the old shows and rebroadcast an internet station/part 15, WNAR.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

38-116xx project - by bm071 - 12-02-2011, 09:19 PM

Re: 38-116xx project - by TA Forbes - 12-02-2011, 10:35 PM

Re: 38-116xx project - by 7estatdef - 12-02-2011, 10:48 PM

Re: 38-116xx project - by bm071 - 12-03-2011, 12:21 AM

Re: 38-116xx project - by 7estatdef - 12-03-2011, 05:50 PM

Re: 38-116xx project - by TA Forbes - 12-04-2011, 02:01 PM

Re: 38-116xx project - by 7estatdef - 12-04-2011, 03:37 PM

Re: 38-116xx project - by bm071 - 12-05-2011, 01:54 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 610B oscillator wiring
I don't know what you are referring to when you say "tube cathode ground". Ground is a connection to the chass...RodB — 05:56 PM
Zenith H725
Good points, Arran. I haven't encountered this problem with any other radio (all earlier vintages), so am learning here....EdHolland — 05:32 PM
Zenith H725
Ed; One thing that I will say about these is that Brand Z was considerate enough to make these mica caps easily acces...Arran — 02:34 PM
Philco 610B oscillator wiring
Do you know what run # your chassis is? It took me a while to find what you were basing updates/modification on as I did...Radioroslyn — 07:34 AM
Need to purchase some accessories for restoration of my Old Philco Radio
COLLEAGUES, Thank you all for such good and important suggestions as how to find good replacement parts. I will go fo...palonso — 07:05 AM
Zenith H725
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM
Zenith H725
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM
My Philco 37-116 Restore
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me