Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-616 needs feet?
#4

Thanks, Rocketeer and Ron, for your replies. Seeing the back of an intact 41-616 is a big help. My set has a Garrard RC-80 phonograph which was hacked in while the Mystery Remote control wiring was hacked out of the chassis for some reason, according to Alfred Corbin, who's bringing this one back to life. I'll post in the Electronics thread about that as we need more info.
As Rocketeer noted, the set looks fine without the feet, since I've never seen it with them.
I cannot tell from the photos whether the back two feet are different or just the side view of the front counterparts. Ron, If you can get close ups with some measurements that would be awesome but not time critical. These can always be added later plus I'd need to find someone talented enough to try to reproduce these from a set of photos with basic measurements.
Thank you both...

Mark


Messages In This Thread
41-616 needs feet? - by mat68046 - 12-01-2011, 01:26 AM
Re: 41-616 needs feet? - by rocketeer - 12-02-2011, 10:04 AM
Re: 41-616 needs feet? - by Ron Ramirez - 12-02-2011, 09:02 PM
Re: 41-616 needs feet? - by mat68046 - 12-04-2011, 06:08 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>