1000 V Capacitors in 41-250

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

1000 V Capacitors in 41-250

OldJack1969
Junior Member

Posts: 21
Threads: 3
Joined: Dec 2011
City: North Las Vegas, NV

12-08-2011, 05:59 PM

I just got a unit like this Model 41-280, where can I get capacitors! I can't find the .003 1000 Volt, and what type should I be looking for to replace these wax paper capacitors. Film Axial ? I really need help with this project.
Also, I lose volume when I use both #41 tubes, but works with just one tube, sounds better but not at full strength.
Anyone with this experience?

Find

« Next Oldest | Next Newest »

Messages In This Thread

1000 V Capacitors in 41-250 - by Raleigh - 05-06-2007, 09:56 PM

[No subject] - by Ron Ramirez - 05-13-2007, 02:13 PM

Re: 1000 V Capacitors in 41-250 - by OldJack1969 - 12-08-2011, 05:59 PM

Re: 1000 V Capacitors in 41-250 - by exray - 12-08-2011, 08:15 PM

Re: 1000 V Capacitors in 41-250 - by Ron Ramirez - 12-09-2011, 08:41 PM

Re: 1000 V Capacitors in 41-250 - by codefox1 - 12-10-2011, 12:30 AM

Re: 1000 V Capacitors in 41-250 - by Texasrocker - 12-10-2011, 01:26 AM

Re: 1000 V Capacitors in 41-250 - by Marsupial - 12-10-2011, 05:24 PM

Re: 1000 V Capacitors in 41-250 - by exray - 12-10-2011, 06:18 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 2791 online users. [Complete List]
» 2 Member(s) | 2789 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me