Philco 47-1230 Knobs & phono question

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 47-1230 Knobs & phono question

49Stude63
Member

Posts: 225
Threads: 14
Joined: Oct 2005
City: Grand Blanc, Michigan

#11

10-20-2006, 10:53 PM

The knobs were used on the 46-1209 also they are the marbarlized with the arrows and used on many other Philcos. On the 4 tape squares if you take them off you may get some problems, I had an issue with a 1209 and once I put the tape square back on the problem was corrected.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 47-1230 Knobs & phono question - by bill T - 10-12-2006, 06:38 AM

[No subject] - by Ron Ramirez - 10-12-2006, 09:19 AM

[No subject] - by Ron Ramirez - 10-12-2006, 09:31 AM

Good Info !!! - by bill T - 10-12-2006, 08:21 PM

[No subject] - by Ron Ramirez - 10-16-2006, 03:55 PM

[No subject] - by bill T - 10-18-2006, 07:40 PM

[No subject] - by Ron Ramirez - 10-18-2006, 11:21 PM

[No subject] - by Poston Drake - 10-19-2006, 01:03 AM

[No subject] - by bill T - 10-20-2006, 06:57 AM

[No subject] - by bill T - 10-20-2006, 07:26 PM

[No subject] - by 49Stude63 - 10-20-2006, 10:53 PM

[No subject] - by Ron Ramirez - 10-21-2006, 08:30 PM

[No subject] - by bill T - 10-25-2006, 10:54 PM

Final answer on knobs - by bill T - 12-17-2006, 08:40 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 2791 online users. [Complete List]
» 3 Member(s) | 2788 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me