1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 42-1009 code 122 help
Eric
Senior Member
****
Posts: 451
Threads: 85
Joined: Nov 2011
City: Cumming, GA
#7

12-09-2011, 12:14 PM
Need more help!
Got the turntable going (running, new motor mounts from VM) do not have any music playing. I do get a load hum when tying it to pin 3 (grid) on the 7C6 (same point where the input xformer lead is), Have tried this with the input Xformer both connected and out of the ckt less buzz with it out. I can hear the music from the needle on the turntable so that seems to be working? What else can I check or change. Thanks
Eric
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 42-1009 code 122 help - by Eric - 11-25-2011, 10:48 AM
Re: Philco 42-1009 code 122 help - by 7estatdef - 11-25-2011, 09:18 PM
Re: Philco 42-1009 code 122 help - by Eric - 11-27-2011, 12:16 PM
Re: Philco 42-1009 code 122 help - by 7estatdef - 11-27-2011, 06:25 PM
Re: Philco 42-1009 code 122 help - by Eric - 11-27-2011, 07:36 PM
Re: Philco 42-1009 code 122 help - by 7estatdef - 11-27-2011, 11:42 PM
Re: Philco 42-1009 code 122 help - by Eric - 12-09-2011, 12:14 PM
Re: Philco 42-1009 code 122 help - by 7estatdef - 12-09-2011, 11:45 PM
Re: Philco 42-1009 code 122 help - by Eric - 12-10-2011, 07:04 PM
Re: Philco 42-1009 code 122 help - by Eric - 12-13-2011, 11:05 PM
Re: Philco 42-1009 code 122 help - by 7estatdef - 12-14-2011, 05:46 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration