Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Mohawk Products at Pond Cove Paint
#4

Yow, Ultra Classic for $4.95 and Tone Finish for $5.25 at the Wood Finishers Store. Excellent prices.

My buddy GlennPR told me recently that there is a local outfit selling the stuff cheaper than Pond Cove, also. But not everyone has a local outlet for Mohawk products; thus, online ordering is the only option for some.

So, now that all of us have been made aware of the Wood Finishers Store, if you have to buy your lacquer online, save some $$$ and go there. Why not? No minimum orders, also. What a deal!

But you can't find out how much shipping costs are (these folks are in California, by the way) unless you create an account with them, put some items in your shopping cart, and proceed to checkout.

Whatever. I think I'll go listen to some Rammstein.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Re: Mohawk Products at Pond Cove Paint - by Arran - 12-09-2011, 05:47 PM
Re: Mohawk Products at Pond Cove Paint - by Ron Ramirez - 12-09-2011, 08:31 PM
Re: Mohawk Products at Pond Cove Paint - by Dave - 12-10-2011, 01:57 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>