Philco Model 48-1256 Humming and no sound from speaker

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

rogerbent
Unregistered

01-01-2012, 09:37 PM

Try http://www.west-techservices.com. They do a fine job rebuilding phono cartridges. I have used them several times quite satisfactorily. They're easy to deal with, too.

« Next Oldest | Next Newest »

Messages In This Thread

Philco Model 48-1256 Humming and no sound from speaker - by Guest - 07-28-2008, 09:27 AM

Re: Philco Model 48-1256 Humming and no sound from speaker - by denver - 01-14-2010, 01:46 PM

Re: Philco Model 48-1256 Humming and no sound from speaker - by 7estatdef - 01-14-2010, 07:29 PM

Re: Philco Model 48-1256 Humming and no sound from speaker - by lwphinney74 - 06-18-2011, 04:29 PM

Re: Philco Model 48-1256 Humming and no sound from speaker - by 7estatdef - 06-18-2011, 08:29 PM

Re: Philco Model 48-1256 Humming and no sound from speaker - by lwphinney74 - 06-18-2011, 10:47 PM

Re: Philco Model 48-1256 Humming and no sound from speaker - by Arran - 06-21-2011, 06:43 PM

Re: Philco Model 48-1256 Humming and no sound from speaker - by rogerbent - 01-01-2012, 09:37 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 6186 online users. [Complete List]
» 4 Member(s) | 6182 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me