Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Crosley 148
#6

Thanks for all the replies. the pot looks original to me it has a brass shaft is 1.5" dia and 7/8" thick (big) and from off to full rotation is 3/4 turn of the shaft. I believe it has been repaired as the seam where it splits has been soldered in about 4 places and not very neatly. I decided to open it and it is a wire wound pot I cleaned it with qtips wet with alcohol and it seems to be operating better I measure 5k across 1 and 3 And the center (wiper) was all over the place but the more I cleaned ( gently) the better it has gotten will pick up a 5k pot as a backup


Messages In This Thread
Crosley 148 - by Eric - 01-18-2012, 05:13 PM
Re: Crosley 148 - by Glenn Roberts - 01-18-2012, 06:27 PM
Re: Crosley 148 - by 7estatdef - 01-18-2012, 07:45 PM
Re: Crosley 148 - by Texasrocker - 01-18-2012, 09:22 PM
Re: Crosley 148 - by Carl Travis - 01-18-2012, 11:19 PM
Re: Crosley 148 - by Eric - 01-19-2012, 12:21 PM
Re: Crosley 148 - by TA Forbes - 01-19-2012, 06:18 PM



Users browsing this thread: 1 Guest(s)