Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 87 alignment question/RESULTS
#3

OK, thanks. In the meantime, I had the radio on and what does this tell you: with no antenna wire or ground, I get the three strong stations crystal clear. However, the volume control does nothing. They are all at about the correct listening level, but I can't increase or decrease the volume. (I've checked the pot with my DVOM and it's fine) Adding my long wire does not increase the signal or volume. Now if I go up to a station 25 miles away (580), I need the long wire and at that station, the volume works as it should. If I tune down to 910 ( a strong local station), I still can't turn it down in volume. That control on the far right has some effect, but I can never get a strong station to go from nothing to very loud.


Messages In This Thread
Re: Philco 87 alignment question - by Ron Ramirez - 01-21-2012, 06:00 PM
Re: Philco 87 alignment question - by DKinYORKpa - 01-21-2012, 06:41 PM
Re: Philco 87 alignment question - by Ron Ramirez - 01-21-2012, 09:18 PM
Re: Philco 87 alignment question - by DKinYORKpa - 01-22-2012, 11:58 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
With regard to the speaker, unless the cone is so brittle that it crumbles as soon as you touch it I would try to repair...Arran — 04:07 AM
Philco 42-345 Restoration/Repair
That silver can capacitor is an aluminum electrolytic. You should replace it with an aluminum electrolytic with the valu...RodB — 11:46 PM
Philco 42-345 Restoration/Repair
Thank you Rodb and Gary for helping with clarification on these capacitors. Other than the Tiny 630volt one I'm not sure...osanders0311 — 10:17 PM
1949 Motorola 5A9M
Hello All; I found the CMB41L down in the basement, it is definitely a 1950-51 model, the capacitors have date codes ...Arran — 07:48 PM
Philco 42-345 Restoration/Repair
Hi, all the caps I order, other than the electrolytics, are of the 630V rating. No worries on it being too high, and no ...gary rabbitt — 05:46 PM
Philco 42-345 Restoration/Repair
Hi, there's a lot to consider when designing these circuits so you shouldn't have a lot of concern when replacing caps. ...RodB — 02:03 PM
Philco 42-345 Restoration/Repair
I have ordered and received new caps for this radio and hope I've ordered the correct ones. I tried matching them to the...osanders0311 — 11:35 AM
Philco newbie with P-1891-WA console questions
Hello Jeff , Far as the Electrolytic capacitors go here is a list of parts. that will work . I like using Nichicon and...radiorich — 09:50 PM
Philco newbie with P-1891-WA console questions
Well, I've been stumped at trying to get the first of 11 electrolytic capacitors. I got a schematic and have a list of t...Jeffcon — 07:54 PM
Model 80 Antenna Issue?
Thanks Gary and Rod.  I also found an article in the Philco Repair Bench under Service Hints and Tips, about installi...Hamilton — 12:32 PM

[-]
Who's Online
There are currently no members online.

>