1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
PT-25 and 48-200 restoration
winkydink
Member
***
Posts: 99
Threads: 24
Joined: Jan 2012
City: Cape May State, Province, Country: New Jersey
#1

01-24-2012, 02:48 PM
I am new to the forum, and new to radio restoration.

As my first project I am planning to recap a PT-25 and possibly a 46-200.

Can someone give me the heads up as to what capacitors I will need to purchase for this project. Also is this something I can purchase as a "kit" or just a seperate items (and which vendor should I go with).

The PT-25 is DOA. The 46-200 does work, but additionally the cord need to be replaced and the stations come in with alot of static.

Any assistance would be appreciated.
Find
« Next Oldest | Next Newest »


Messages In This Thread
PT-25 and 48-200 restoration - by winkydink - 01-24-2012, 02:48 PM
Re: PT-25 and 48-200 restoration - by codefox1 - 01-24-2012, 04:11 PM
Re: PT-25 and 48-200 restoration - by voroush - 02-01-2012, 02:49 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6761 online users. [Complete List]
» 1 Member(s) | 6760 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration