Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Farm radio consoles
#5

Chris

Kutztown is southwest of Allentown, between Allentown and Reading, off US 222 on the south side of town.

More info may be found here (note: this page advertises the 2006 meets, but this will give you an idea):
http://www.renningers.com/kutzradio.htm

I've never attended this meet, but I hear it is a very good one. (I drove through on US 222 in an eighteen wheeler when I was driving a big truck earlier this year, which is why I sort of know where Kutztown is.)

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Farm radio consoles - by Chris Drumma - 11-09-2006, 12:27 PM
[No subject] - by Ron Ramirez - 11-09-2006, 01:02 PM
[No subject] - by Chris Drumma - 11-09-2006, 01:39 PM
[No subject] - by Bill Hutchinson - 11-09-2006, 04:39 PM
[No subject] - by Ron Ramirez - 11-09-2006, 07:29 PM
[No subject] - by Bill Hutchinson - 11-09-2006, 09:13 PM
[No subject] - by jsaxe - 11-12-2006, 01:56 PM
[No subject] - by Chris Drumma - 11-13-2006, 10:50 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 2993 online users. [Complete List]
» 4 Member(s) | 2989 Guest(s)
AvatarAvatarAvatarAvatar

>