01-29-2012, 02:56 PM
Should the other tubes remain in when I do this test?
Because I had them all out when I did the test. I put the positive probe in pin 3 and the negative I put on the chassis. My meter was at 500V DC, and the needle hardly budged.![Icon_sad Icon_sad](https://philcoradio.com/phorum/images/smilies/icon_sad.gif)
The dial lamp burned brightly the entire time.
:
Because I had them all out when I did the test. I put the positive probe in pin 3 and the negative I put on the chassis. My meter was at 500V DC, and the needle hardly budged.
![Icon_sad Icon_sad](https://philcoradio.com/phorum/images/smilies/icon_sad.gif)
The dial lamp burned brightly the entire time.
![Icon_confused Icon_confused](https://philcoradio.com/phorum/images/smilies/icon_confused.gif)