Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-116 distortion
#6

Yes we are talking about the same transformer feeding the 6L6 output tubes. It is a phase inverter feeding the push-pull outputs. Try reversing one of the secondary windings connections. If that clears it up, you're done. If not, put it back the way it was and reverse the other secondary winding connections.

Let us know it that does it.

Schematic here:
http://www.nostalgiaair.org/PagesByModel...013234.pdf


Messages In This Thread
38-116 distortion - by bm071 - 01-29-2012, 06:32 PM
Re: 38-116 distortion - by codefox1 - 01-29-2012, 07:16 PM
Re: 38-116 distortion - by bm071 - 01-29-2012, 08:03 PM
Re: 38-116 distortion - by 7estatdef - 01-29-2012, 09:26 PM
Re: 38-116 distortion - by bm071 - 01-29-2012, 10:17 PM
Re: 38-116 distortion - by codefox1 - 01-30-2012, 12:15 PM
Re: 38-116 distortion - by bm071 - 01-30-2012, 01:15 PM
Re: 38-116 distortion - by 7estatdef - 01-30-2012, 03:33 PM
Re: 38-116 distortion - by bm071 - 01-30-2012, 10:33 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

[-]
Who's Online
There are currently 6144 online users. [Complete List]
» 1 Member(s) | 6143 Guest(s)
Avatar

>