Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

mod 46 1213 repair
#5

Thanks for the help so far. I'm not an electrical engineer by any means but I'm pretty mechanically inclined so to speak. The connection theat runs from the phonograph to the speaker has what looks to be a capacitory and a connection needs to be replaced or rebuilt from what I can tell. Is this a capacitor at this location and if so, where could I aquire a new one? Also, the light bulbs are mostly dead. I saw some similar ones at the auto parts store, would they work if they were calibrated for the same voltage and wattage?


Messages In This Thread
mod 46 1213 repair - by altera6 - 01-26-2012, 04:47 AM
Re: mod 46 1213 repair - by Eliot Ness - 01-26-2012, 09:37 AM
Re: mod 46 1213 repair - by altera6 - 01-26-2012, 09:04 PM
Re: mod 46 1213 repair - by Eliot Ness - 01-29-2012, 09:59 AM
Re: mod 46 1213 repair - by altera6 - 01-31-2012, 05:56 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 4649 online users. [Complete List]
» 3 Member(s) | 4646 Guest(s)
AvatarAvatarAvatar

>