Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My New Marconi
#3

Nice set, I take that you also reside in Canada since you had one of these before. Marconis from the 1930s had some very nice cabinets, even nicer then many Rogers sets in my opinion. I don't know who made these cabinets for Marconi but I suspect that it may have been Victoriaville Furniture or another Quebec based cabinet maker since Marconi was based in Montreal, but then again I have a Marconi type 12 from 1928 where McLagan Furniture built the cabinet and they were based in Oshawa.
As for touching up the top I'm not sure how successful that might be, as you can see the top and the control panel is one piece, so whatever you do to the top has to blend in with the rest. It looks like the feet at the base of the skirt/toe kick is almost bare, that portion would have to be refinished, perhaps selectively by masking it off from the rest. It wouldn't necessarily be a bad thing to strip the cabinet and start over, but without seeing the rest it's hard to say.
Regards
Arran


Messages In This Thread
My New Marconi - by Dan Walker - 01-30-2012, 01:37 AM
Re: My New Marconi - by Texasrocker - 01-30-2012, 11:52 PM
Re: My New Marconi - by Arran - 02-09-2012, 01:15 AM
Re: My New Marconi - by Dan Walker - 02-12-2012, 05:39 PM
Re: My New Marconi - by Ron Ramirez - 02-12-2012, 07:35 PM
Re: My New Marconi - by Arran - 02-12-2012, 10:50 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>