Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

50-922 Output Tube
#5

Here is a good link to the schematic http://www.nostalgiaair.org/Resources/702/M0013702.htm

Rob


Messages In This Thread
50-922 Output Tube - by deshawn - 02-09-2012, 12:24 AM
RE: 50-922 Output Tube - by deshawn - 03-05-2012, 12:41 AM
RE: 50-922 Output Tube - by codefox1 - 03-05-2012, 12:58 PM
RE: 50-922 Output Tube - by deshawn - 03-08-2012, 02:43 PM
Re: 50-922 Output Tube - by codefox1 - 02-09-2012, 12:02 PM
Re: 50-922 Output Tube - by deshawn - 02-09-2012, 12:32 PM
50-922 Missing Capacitor - by deshawn - 02-10-2012, 05:34 PM
Re: 50-922 Output Tube - by Olden Broak - 02-10-2012, 11:56 PM
Re: 50-922 Output Tube - by deshawn - 02-11-2012, 05:26 PM
Re: 50-922 Output Tube - by Ron Ramirez - 02-11-2012, 09:45 PM
Re: 50-922 Output Tube - by deshawn - 02-14-2012, 02:46 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6304 online users. [Complete List]
» 2 Member(s) | 6302 Guest(s)
AvatarAvatar

>