1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 91 Mystery
Mark H
New Member
*
Posts: 2
Threads: 1
Joined: Feb 2012
#4

02-11-2012, 10:23 AM
Thanks for you reply Ron, I was very anxious to hear what you had to say. The Philco 91 that I have is just the AM band model. Norm and Curtis were very helpful to me on ARF. I was very reluctant to make that kind of change to my radio without back up from expets. I am not an expert by any means. I was not able to find anything about Philco changing the BC resistor, so again, thanks for all the info...it really helps explain things for me. The radio is working wonderfully now.

Thanks,
Mark H
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 91 Mystery - by Mark H - 02-10-2012, 09:11 AM
Re: Philco 91 Mystery - by LASJayhawk - 02-10-2012, 11:33 PM
Re: Philco 91 Mystery - by Ron Ramirez - 02-11-2012, 10:01 AM
Re: Philco 91 Mystery - by Mark H - 02-11-2012, 10:23 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3732 online users. [Complete List]
» 4 Member(s) | 3728 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration