1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 87 Highboy
Skip
Member
***
Posts: 76
Threads: 20
Joined: Oct 2010
City: Oskaloosa State, Province, Country: KANSAS
#8

02-16-2012, 02:44 PM
That is what I thought but wanted to be sure.

Thanks
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 87 Highboy - by Skip - 01-30-2012, 07:50 PM
Re: Philco 87 Highboy - by 7estatdef - 01-30-2012, 10:32 PM
Re: Philco 87 Highboy - by Skip - 01-31-2012, 08:45 AM
Re: Philco 87 Highboy - by Chuck Schwark - 01-31-2012, 02:13 PM
Re: Philco 87 Highboy - by TA Forbes - 01-31-2012, 02:35 PM
Re: Philco 87 Highboy - by Skip - 02-15-2012, 09:42 PM
Re: Philco 87 Highboy - by 7estatdef - 02-16-2012, 08:29 AM
Re: Philco 87 Highboy - by Skip - 02-16-2012, 02:44 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6538 online users. [Complete List]
» 5 Member(s) | 6533 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration