New Project - 39-55

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

New Project - 39-55

ipwizard
Senior Member

Posts: 335
Threads: 50
Joined: Apr 2011
City: Apple Creek State, Province, Country: Ohio

#14

02-28-2012, 11:43 PM

Would it be worth while to power it up on the bench and check voltages. I know would be high with no load on them but i could atleast see if the trans gets warm or hot wihtout any load on it.

Worth a shot?

-Keith

Find

« Next Oldest | Next Newest »

Messages In This Thread

New Project - 39-55 - by ipwizard - 02-28-2012, 04:26 PM

RE: New Project - 39-55 - by codefox1 - 02-28-2012, 04:40 PM

RE: New Project - 39-55 - by ipwizard - 02-28-2012, 04:46 PM

RE: New Project - 39-55 - by ipwizard - 02-28-2012, 04:45 PM

RE: New Project - 39-55 - by ipwizard - 02-28-2012, 05:00 PM

RE: New Project - 39-55 - by Glenn Roberts - 02-28-2012, 05:45 PM

RE: New Project - 39-55 - by Bob Andersen - 02-28-2012, 07:02 PM

RE: New Project - 39-55 - by Ron Ramirez - 02-28-2012, 07:06 PM

RE: New Project - 39-55 - by ipwizard - 02-28-2012, 07:13 PM

RE: New Project - 39-55 - by Ron Ramirez - 02-28-2012, 07:17 PM

RE: New Project - 39-55 - by ipwizard - 02-28-2012, 08:01 PM

RE: New Project - 39-55 - by Ron Ramirez - 02-28-2012, 08:11 PM

RE: New Project - 39-55 - by codefox1 - 02-28-2012, 11:23 PM

RE: New Project - 39-55 - by ipwizard - 02-28-2012, 11:43 PM

RE: New Project - 39-55 - by codefox1 - 02-29-2012, 01:31 AM

RE: New Project - 39-55 - by ipwizard - 03-01-2012, 12:32 AM

RE: New Project - 39-55 - by codefox1 - 03-01-2012, 07:04 AM

RE: New Project - 39-55 - by ipwizard - 03-06-2012, 06:37 PM

RE: New Project - 39-55 - by Arran - 03-06-2012, 09:14 PM

RE: New Project - 39-55 - by ipwizard - 03-06-2012, 07:04 PM

RE: New Project - 39-55 - by ipwizard - 03-06-2012, 11:27 PM

RE: New Project - 39-55 - by Arran - 03-10-2012, 12:52 AM

RE: New Project - 39-55 - by codefox1 - 03-06-2012, 09:34 PM

RE: New Project - 39-55 - by Bob Andersen - 03-07-2012, 12:03 AM

RE: New Project - 39-55 - by ipwizard - 03-07-2012, 12:21 AM

RE: New Project - 39-55 - by ipwizard - 03-07-2012, 01:42 AM

RE: New Project - 39-55 - by Ron Ramirez - 03-11-2012, 08:51 AM

RE: New Project - 39-55 - by ipwizard - 03-10-2012, 11:59 AM

RE: New Project - 39-55 - by Arran - 03-10-2012, 09:15 PM

RE: New Project - 39-55 - by ipwizard - 03-11-2012, 01:45 AM

RE: New Project - 39-55 - by Ron Ramirez - 03-11-2012, 08:38 AM

RE: New Project - 39-55 - by Ron Ramirez - 03-11-2012, 10:51 AM

RE: New Project - 39-55 - by w4rtc - 03-11-2012, 11:03 AM

RE: New Project - 39-55 - by ipwizard - 04-06-2012, 01:04 AM

RE: New Project - 39-55 - by ipwizard - 04-11-2012, 01:10 AM

RE: New Project - 39-55 - by ipwizard - 04-13-2012, 01:47 AM

RE: New Project - 39-55 - by codefox1 - 04-13-2012, 02:11 AM

View a Printable Version

Users browsing this thread: 14 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me