1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 60 "Safety Caps" ?
lyle
Junior Member
**
Posts: 46
Threads: 9
Joined: Feb 2012
City: Oregon
#3

03-01-2012, 10:52 PM
Thank you, so much! I have spent years trying to figure this stuff out by myself. I can't tell you how nice it is to have knowledgeable folks like you to check with. I hope someday I can do the same.

lyle
I may not be very good, but I'm slow.
(This post was last modified: 03-01-2012, 10:53 PM by lyle.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 60 "Safety Caps" ? - by lyle - 03-01-2012, 08:35 PM
RE: Philco 60 "Safety Caps" ? - by Bob Andersen - 03-01-2012, 09:48 PM
RE: Philco 60 "Safety Caps" ? - by Arran - 03-02-2012, 01:23 AM
RE: Philco 60 "Safety Caps" ? - by lyle - 03-02-2012, 12:22 PM
RE: Philco 60 "Safety Caps" ? - by TexMac - 03-08-2012, 04:41 AM
RE: Philco 60 "Safety Caps" ? - by Arran - 03-08-2012, 11:46 PM
RE: Philco 60 "Safety Caps" ? - by lyle - 03-01-2012, 10:52 PM
RE: Philco 60 "Safety Caps" ? - by TexMac - 03-09-2012, 02:59 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 4081 online users. [Complete List]
» 1 Member(s) | 4080 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration