Resistor substitution 20% range?

Register

Guest Join Us

Hello Guest,

Please feel free to join us!
There are many more parts of the Phorum that only members can see.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Resistor substitution 20% range?

lyle
Junior Member

Posts: 46
Threads: 9
Joined: Feb 2012
City: Oregon

#8

03-03-2012, 12:49 PM

(03-02-2012, 09:56 PM)7estatdef Wrote: I'll add to what Codefox sez. Back in the day alot of resistors where standard values now days not all of these older resistors are standard anymore. So you may not be able to find the exact value but bear in mind that back then 20 percent was standard.So you've got a fairly broad range to pick from. WELCOME TO THE PHORUM!!!
Terry

Thanks,

This Phorum and you folks are great.

Thanks for your reply.

lyle

I may not be very good, but I'm slow.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Resistor substitution 20% range? - by lyle - 03-02-2012, 07:29 PM

RE: Resistor substitution 20% range? - by codefox1 - 03-02-2012, 08:30 PM

RE: Resistor substitution 20% range? - by lyle - 03-02-2012, 09:15 PM

RE: Resistor substitution 20% range? - by 7estatdef - 03-02-2012, 09:56 PM

RE: Resistor substitution 20% range? - by codefox1 - 03-02-2012, 10:45 PM

RE: Resistor substitution 20% range? - by lyle - 03-03-2012, 12:52 PM

RE: Resistor substitution 20% range? - by codefox1 - 03-04-2012, 12:42 PM

RE: Resistor substitution 20% range? - by lyle - 03-05-2012, 01:01 PM

RE: Resistor substitution 20% range? - by lyle - 03-03-2012, 12:49 PM

RE: Resistor substitution 20% range? - by Arran - 03-03-2012, 12:18 AM

RE: Resistor substitution 20% range? - by lyle - 03-03-2012, 12:40 PM

RE: Resistor substitution 20% range? - by Arran - 03-06-2012, 12:47 AM

RE: Resistor substitution 20% range? - by lyle - 03-07-2012, 12:35 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 5420 online users. [Complete List]
» 1 Member(s) | 5419 Guest(s)