1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
speaker repair
TexMac
Member
**
Posts: 12
Threads: 0
Joined: Jun 2010
City: Leesburg, TX
#4

03-09-2012, 03:17 AM
Small holes, I also patch with tea bags. For tears with no pieces missing, I butt join them with E6000 scrap-bookers' adhesive available at the craft stores. It is a non-acidic silicone glue that stays flexible. I sort of rub it into the cone paper with my finger tip to make sure it penetrates the fibers. The finished spread is less than 1/4 inch when done. It does dry shiny, though.
Ron Mc/
Find
« Next Oldest | Next Newest »


Messages In This Thread
speaker repair - by winkydink - 03-08-2012, 10:47 AM
RE: speaker repair - by Glenn Roberts - 03-08-2012, 01:53 PM
RE: speaker repair - by Dave - 03-08-2012, 03:59 PM
RE: speaker repair - by TexMac - 03-09-2012, 03:17 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 5027 online users. [Complete List]
» 5 Member(s) | 5022 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration