new fm?

Thread Rating:

new fm?

Ron Ramirez
Silent Key

Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana

03-11-2012, 11:55 AM

Can you give us the link to the site where you found this? More info would be helpful.

--
Ron Ramirez
Ferdinand IN

Find

« Next Oldest | Next Newest »

Messages In This Thread

new fm? - by fixinmyphilco - 03-11-2012, 11:17 AM

RE: new fm? - by Ron Ramirez - 03-11-2012, 11:55 AM

RE: new fm? - by fixinmyphilco - 03-11-2012, 12:01 PM

RE: new fm? - by Ron Ramirez - 03-11-2012, 01:02 PM

RE: new fm? - by fixinmyphilco - 03-11-2012, 01:05 PM

RE: new fm? - by 7estatdef - 03-11-2012, 08:59 PM

RE: new fm? - by LASJayhawk - 03-14-2012, 09:16 PM

RE: new fm? - by fixinmyphilco - 03-14-2012, 09:40 PM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6935 online users. [Complete List]
» 1 Member(s) | 6934 Guest(s)