1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco Model 60 coils
sjhs1962
Junior Member
**
Posts: 44
Threads: 9
Joined: Apr 2011
City: Pittsburgh, PA
#8

03-19-2012, 08:51 PM
(03-19-2012, 04:33 PM)7estatdef Wrote:  If the primary of the ant coil as open you can hook the ant to the grid cap of the mixer tube and you should be able to receive radio signals. Is you local oscillator working?
Terry

http://www.philcoradio.com/tech/60evol.htm
No, oscillator not working. In addition plate voltages are high 370 vdc. Also, resistor on band switch measures 11 ohms ...schematic says 10k, but I have another 60 in a different version that works and this resistor also measures 11 ohms. Confused. Antenna on grid cap of 6A7 doesn't bring in anything.
(This post was last modified: 03-19-2012, 08:52 PM by sjhs1962.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco Model 60 coils - by sjhs1962 - 02-27-2012, 08:51 PM
RE: Philco Model 60 coils - by 7estatdef - 02-27-2012, 08:56 PM
RE: Philco Model 60 coils - by sjhs1962 - 02-27-2012, 09:29 PM
RE: Philco Model 60 coils - by 7estatdef - 02-27-2012, 10:10 PM
RE: Philco Model 60 coils - by sjhs1962 - 03-19-2012, 08:39 AM
RE: Philco Model 60 coils - by codefox1 - 03-19-2012, 01:59 PM
RE: Philco Model 60 coils - by 7estatdef - 03-19-2012, 04:33 PM
RE: Philco Model 60 coils - by sjhs1962 - 03-19-2012, 08:51 PM
RE: Philco Model 60 coils - by morzh - 03-19-2012, 09:14 PM
RE: Philco Model 60 coils - by sjhs1962 - 03-19-2012, 09:44 PM
RE: Philco Model 60 coils - by Chuck Schwark - 03-20-2012, 08:27 AM
RE: Philco Model 60 coils - by 7estatdef - 03-21-2012, 06:18 PM
RE: Philco Model 60 coils - by Ron Ramirez - 03-21-2012, 06:38 PM
RE: Philco Model 60 coils - by 37fordcab - 05-10-2012, 11:01 AM
RE: Philco Model 60 coils - by sjhs1962 - 03-22-2012, 08:02 PM
RE: Philco Model 60 coils - by sjhs1962 - 04-02-2012, 01:39 PM
RE: Philco Model 60 coils - by Chuck Schwark - 04-02-2012, 01:47 PM
RE: Philco Model 60 coils - by CrumblingWires - 04-05-2012, 06:22 PM
RE: Philco Model 60 coils - by Bob Andersen - 04-05-2012, 10:18 PM
RE: Philco Model 60 coils - by sjhs1962 - 04-11-2012, 09:42 PM
RE: Philco Model 60 coils - by Bob Andersen - 04-12-2012, 10:08 AM
RE: Philco Model 60 coils - by sjhs1962 - 04-12-2012, 02:44 PM
RE: Philco Model 60 coils - by Bob Andersen - 04-12-2012, 02:59 PM
RE: Philco Model 60 coils - by sjhs1962 - 04-18-2012, 01:15 PM
RE: Philco Model 60 coils - by 7estatdef - 04-18-2012, 04:41 PM
RE: Philco Model 60 coils - by 7estatdef - 05-10-2012, 06:59 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration