Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-116X What's The Price Point?
#13

(03-23-2012, 03:30 PM)Gene Pederson Wrote:  When I mentioned the probability of the rubber covered wiring the guy says he has worked on electronics since the 70's. All the knobs are missing. Small veneer chip on the top. I don't know who told him it's worth a lot more, but I agree that consoles are harder to sell. I had trouble GIVING one away! The chassis sounds somewhat intimidating to me also.

Maybe I should go look at an RCA K130 instead. That's $150 and a lot closer.

Gene

It's a bit off topic but in what shape is the K130? It looks like a 1939-40 set, but it also has a Tenite bezel and pushbuttons which can have problems. It looks like a good set but keep in mind it's less collectable then a set from 1936-37 so people will usually pay less for one then an earlier set. It's up to you of course but I would only go for it if everything is there and in good shape, and I would still make an offer unless someone actually restored the thing at some point. Maybe we can move this to the non Philco section if you like.
Regards
Arran



Messages In This Thread
RE: Philco 37-116X What's The Price Point? - by Arran - 03-23-2012, 07:13 PM



Users browsing this thread: 24 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM

[-]
Who's Online
There are currently no members online.

>