Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Admiral/Continental 960-8K
#5

Hi Gene,
I've got a RPC set myself. It's a bit of an oddball job. http://www.flickr.com/photos/53710524@N0...hotostream
haven't been able to fine much about it. Was able to get it working ok, it's a TRF set from the early 1930's.
Terry


Messages In This Thread
Admiral/Continental 960-8K - by Gene Pederson - 03-30-2012, 01:38 PM
RE: Admiral/Continental 8KU - by rghines1 - 03-30-2012, 04:05 PM
RE: Admiral/Continental 8KU - by codefox1 - 03-31-2012, 07:24 PM
RE: Admiral/Continental 960-8K - by Jayce - 03-30-2012, 05:20 PM
RE: Admiral/Continental 960-8K - by TA Forbes - 03-30-2012, 11:58 PM
RE: Admiral/Continental 960-8K - by 7estatdef - 03-31-2012, 05:52 PM
RE: Admiral/Continental 960-8K - by Gene Pederson - 04-01-2012, 10:19 PM
RE: Admiral/Continental 960-8K - by Arran - 04-01-2012, 11:52 PM
RE: Admiral/Continental 960-8K - by TA Forbes - 04-02-2012, 12:03 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4763 online users. [Complete List]
» 1 Member(s) | 4762 Guest(s)
Avatar

>