Philco 38-60

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 38-60

Dave
Member

Posts: 91
Threads: 9
Joined: Feb 2010
City: Macon, GA

04-06-2012, 10:00 PM

Not sure if it's a different part, or maybe a missprint or smudge on your parts list, but Chuck has one listed on his site labeled 8328-su. Surf on over to the Philco repair bench and take a peek in the parts value section.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 38-60 - by fixinmyphilco - 03-25-2012, 02:46 PM

RE: Philco 38-60 - by tab10672 - 03-25-2012, 03:27 PM

RE: Philco 38-60 - by TA Forbes - 03-25-2012, 11:47 PM

RE: Philco 38-60 - by fixinmyphilco - 03-26-2012, 06:37 PM

RE: Philco 38-60 - by fixinmyphilco - 04-06-2012, 07:22 PM

RE: Philco 38-60 - by Dave - 04-06-2012, 10:00 PM

RE: Philco 38-60 - by fixinmyphilco - 04-07-2012, 02:54 AM

RE: Philco 38-60 - by Dave - 04-07-2012, 10:41 AM

RE: Philco 38-60 - by TA Forbes - 04-07-2012, 10:53 AM

RE: Philco 38-60 - by fixinmyphilco - 04-12-2012, 05:29 PM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me