Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A Model 52 For Me
#11

An open coil winding in RF or OSC or IF. The green corrosion disease.

Check coils/transformers #2, 5, 8, 12, and 16 for continuity of windings.


Messages In This Thread
A Model 52 For Me - by n9vu - 11-20-2006, 11:38 PM
Re: A Model 52 For Me - by n9vu - 11-20-2006, 11:49 PM
[No subject] - by Chuck Schwark - 11-21-2006, 12:20 AM
[No subject] - by Ron Ramirez - 11-21-2006, 01:28 AM
[No subject] - by n9vu - 11-21-2006, 07:04 AM
[No subject] - by n9vu - 11-21-2006, 07:06 AM
Re: A Model 52 For Me - by n9vu - 11-28-2006, 07:08 AM
[No subject] - by Ron Ramirez - 11-28-2006, 09:18 AM
[No subject] - by n9vu - 11-28-2006, 09:12 PM
[No subject] - by n9vu - 12-04-2006, 11:19 PM
[No subject] - by Chuck Schwark - 12-05-2006, 10:17 AM
[No subject] - by n9vu - 12-05-2006, 09:05 PM
[No subject] - by Chuck Schwark - 12-05-2006, 10:02 PM
[No subject] - by Ron Ramirez - 12-06-2006, 10:35 AM
[No subject] - by n9vu - 12-06-2006, 08:11 PM
[No subject] - by Chuck Schwark - 12-06-2006, 09:39 PM
[No subject] - by Ron Ramirez - 12-06-2006, 09:47 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 2627 online users. [Complete List]
» 3 Member(s) | 2624 Guest(s)
AvatarAvatarAvatar

>