Model 90 Dial Slips On Pulley-FIXED

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Model 90 Dial Slips On Pulley-FIXED

Pepperoni
Member

Posts: 160
Threads: 42
Joined: Apr 2011
City: New Port Richey State, Province, Country: Florida

04-11-2012, 03:30 PM

The dial scale assembly on this Philco model 90 is driven by a small pulley that is spring loaded and has a slot in it. But I don't have to tell you that.

My dial scale assembly is riding in the slot but is very loose most of the length of travel. The dial scale assembly just slips. What causes the spring to keep pressure on the part of the dial scale assembly that rides in that groove? Is it adjustable somehow? There is no lubricant here and all parts have been cleaned thoroughly.

Pepper

"It's Nice To Be Nice To The Nice"
Major Frank Burns Mash 4077th

(This post was last modified: 04-12-2012, 04:44 PM by Pepperoni.)

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 90 Dial Slips On Pulley-FIXED - by Pepperoni - 04-11-2012, 03:30 PM

RE: Model 90 Dial Slips On Pulley - by tab10672 - 04-11-2012, 06:30 PM

RE: Model 90 Dial Slips On Pulley - by Pepperoni - 04-12-2012, 11:48 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 7016 online users. [Complete List]
» 1 Member(s) | 7015 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me